In Additional Config field enter these commands:ĥ. Click Save Startup, and return to the previous VPN tab.Īlso, add this line to the field of Additional Config: usr/sbin/openvpn -config /tmp/openvpncl/nf -route-up /tmp/openvpncl/route-up.sh -down-pre /tmp/openvpncl/route-down.sh -daemon Please make sure to replace USERNAME and PASSWORD with your Surfshark service credentials that can be found at this page under the Credentials tab. We recommend that you avoid changing any other fields.Ĥ.1 ( Optional, depending on step 4.) If you do not see any fields to enter your credentials, please advance to Administration > Commands, and enter these commands: echo " USERNAME Īdvanced Options = Enable (this will enable additional options) Note : If there are no Username and Password fields, fill in the other fields as specified in this tutorial and proceed to step 3.1. Password: Your Surfshark service password that you have found at the " Find your login details" section of this guide. Username: Your Surfshark service username that you have found at the " Find your login details" section of this guide. Server IP/Name: enter the server hostname that you have collected in the " Choose Surfshark server" section of this tutorial. Then, click on the Service tab, select VPN, and find the OpenVPN client. In the DD-WRT control panel open the Setup tab, scroll down to the Network Address Server Settings (DHCP) and enter the following information: You will need to set up Surfshark’s DNS servers. If this one does not work, try the following:ġ92.168.11.1 / 192.168.30.1 (Motorola and some others) Most often, this IP address is used to reach DD-WRT router: 192.168.1.1 You can reach it by entering the IP address of your router to the URL bar in your browser. First of all, you will need to open the control panel of your router.If you prefer connecting to Finland, copy the hostname of Finland - Helsinki server.īefore connecting to the VPN, you will need to configure the OpenVPN client on your router. If you wish to connect to Poland, copy the hostname for Poland - Warsaw or Poland - Gdansk servers. You can find the hostname below the flag icon of each location. You will need a hostname of the VPN server. Copy the hostname of your preferred location - you will use it a bit later. Switch to the Locations section where you will find the list of all servers and their hostnames. You will need these credentials a bit later.Įvery server location has a hostname that you need to use on the router to connect to a particular server. It is a good idea to keep this page open for now. You will find Surfshark service credentials there. In that case, enter your email address and your password, then click Log in. You may need to log in before proceeding to this page. This is the page where you can find all the details required for a manual connection. ![]() Here is how you can get your Surfshark service credentials: You’ll need Surfshark service credentials to connect to the VPN using a manual OpenVPN configuration that is explained below. If you don’t have the subscription yet, you can get it here. It's worth mentioning that your router must have at least 8 MB of flash memory to maintain the VPN connection. To proceed, you need to have a router with DD-WRT firmware and an active Surfshark subscription. In this tutorial, you will learn how to configure the Surfshark VPN tunnel on your DD-WRT router.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |